Specifications:

·         1.5 inch TFT RGB display

·         Passive Power Over Ethernet Device, Ubiquiti, Mikrotik, Cambium, ecc.

·         switchable 24V and 48V - 30W PoE.

·         Not really 802.3at but power up all device 802.3at using 8 wires

·         HotSpot WiFi

·         14000mA/h for charging external devices.

·         2 Hours at 15W at 45°C

·         Short-circuit, Overload, Temperature, Low Output Voltage protection.

·         Automated preparation of CPE antenna. Via Linux script

·         OpenWrt / Lede , HTML menu, working opkg repository

·         VLAN support

·         Iperf3 -s always active

·         Samba 3, for files and memory sharing, USB flash memory.

·         Perfect match with App EasyUBNT, Tik-App, ubnt

·         IEEE 802.3 (Pin 4 e 5 +24V, Pin 7 e 8 GND)

·         For old Cambium CPE you have to create a LAN cable with reversed power pin.

·         One year warranty.

·         Independent state:

o   USB Out (Charge/LED)

o   Wi-Fi

o   PoE On

·         Accessory:

o   Hard Case

o   USB Cable

o   Lan Cabl

o   Cambium Swap Cable

·         280grams

·         86x103x30mm

·         MT7620 chipset 2.4 GHZ

·         Two PCB antennas.

WiFi Speed:

2.5 Ghz Width 40 Mhz =  86 Mbps

2.5 Ghz Width 20 Mhz = 43 Mbps

Optional USB AC Stick

AC 5 Ghz Width 80 Mhz = 292 Mbps

AC 5 Ghz Width 40 Mhz = 150 Mbps

AC 5 Ghz Width 20 Mhz = 72 Mbps

Function of click top button:

·         One click, Wi-Fi Turn On

·         Fast double click, Wi-Fi Turn Off

·         Long last click button, led light Turn On

Functions of 24V / 48V Button 

·         One click, PoE and WiFi Turn on (For Change this, see at the end of the manual)

·         Long last click button, PoE and WiFi Turn Off

·         Fast double click, Show Test

Display:

·         Battery level.

·         PoE voltage

·         Ethernet Status ICON

o   switched off - router off

o   full       – ethernet at 100 Full Duplex

o   half      – Problems with ethernet cable

o   unplg   – Unplugged cable

·         Power delivered

·         config done – When che script successiful

·         config failed – When the script fails

Reset:

·         Pressed to startup, firmware update

·         Pressed 30 seconds, factory reset.

Router / Powerbank Leds:

·         Blue Sx         Ethernet

·         Red               Wi-Fi

·         Yellow           Battery

·         Orange  Dx   Power

Yellow Battery Led:

·         In charging  = Blink

·         End of Charge = On

·         In discharging = ON

·         Low Battery = Blink